session closes due to aging out but the traffic shows allow can someone explain to me what is happening
The setting for the dynamic blocklist gives you the selection of hourly, daily and weekly at _____. I understand the hourly, daily and weekly increment but at refers to what ?
Hi All,
Could you please provide doc for how to take configuration back up for PA5050.
I am planing to upgrade software version .6.0.3 to 6.0.10
Hi
I know that I shuld report by WilDFireportal - I did it many times but now I have a problem.
hxxp://www.kazevid.com/kSCdM3iIRbrKlZ contains malware reported as Trojan-SPY/Win32.emotet.qz or Trojan/Win32.vbkrypt.ynhg.
This email that contains such lin
...
Hello,
How to be status are there 'grayware' on wildfire portal?
I have not seen it.
I expect grayware is between malware and benign.
But I would like to know it correct.
Thanks,
KC Lee
I have everything configured to send syslog information from the palo alto to one of our syslog server. My issue is that none of the security policy IP ranges allows me to send the syslog information for a specific IP address that is going out to th
...
Dears,
We have been facing a lot of users identified by Captive Portal and not via UIA.
Does anyone could suggest any troubleshooting/best practices to avoid this kind of behavior ?
Thanks in advance!!
Dears,
Captive Portal doesn't show up automatically for some Consulting users (laptos out of our windows domain)
Does anyone face this problem before ?
We're having a vulnerability assessment done, and want to make sure that the IDS/IPS part doesn't disable all attempts from the vendors IP addresses, just the application blocking/service blocking.
Can I whitelist the 4 IP addresses and put them in a
...
Hello Friends,
we have 2 firewall active-active HA mode. same LDAP configuration on both firewall. HA Active primary it working fine but secondary is not working. if primary goes down secondary work as a active, its also working fine. but it will not
...
So I'm new to my PA-3020 and trying to get beyond my basic config has introduced a new problem for me.
I have a Layer 3 Cisco connected to my PA eth 1/2 via a routed interface on the switch. My traffic is all working fine now, but I want to make some
...
Looking for some guidance on this. I am seeing a lot of Poodle Bits vulnerability showing up on our threat monitor. Digging into the threat, the first item is always showing our current router (192.168.0.1) followed by two different attacker host fro
...
I recently installed a PA-500 on our network. Currently it is in virtual mode as I start to understand how to configure the device. One of the things I have noticed is that consistently, DNS is the number 1 application. Second is web-browsing. Just
...
Hi All,
Looks like there is a minor GUI bug in the NAT policy section of Panorama. Do you all see the same thing?
Objects:
NameAddressEXT_FW_192.168.0.1192.168.0.1/24EXT_FW_5.5.5.15.5.5.1/24EXT_FW_10.0.0.110.0.0.1/24NAT Rule:
Translated Packet
Type = Dyn
...
Hi people,
I have a PA-2050 that is extremely slow while navigating the management interface. Why is it so?
Thank you for your help
//Ron
| Subject | Likes |
|---|---|
| 6 Likes | |
| 5 Likes | |
| 2 Likes | |
| 2 Likes | |
| 2 Likes |
