Hello,
I like the explicit proxy functionality but missing option to use proxy chaining and forward all the explicit proxy requests to an upstream proxy.
Some ideas how to archive this?
Thanks for any recommendations
Lumir
hello
I am deploying a GP Portal/Gateway configuration on a Panorama platform
the commit to Panorama is successful
the push to the device is failing as shown below
tunnel.199 has a virtual router configured
has anyone seen this issue before ?
...
Hello all,
I requested for a PA-VM evaluation license using 10.0.4, tried using VMware Workstation import the .OVA using 6Gb RAM and 4 cores, everything looks fine, until it gets a management IP a few seconds later says "Broadcast message from root" a
...
PA-440 firewall model name. I can't connect web interface and over console cable. Just power ligth on. STS and TMP ligths are off. what can I do with it.
Hello everyone!
We are going to use custom certificates in our PA deployment. We have 2 WF-500BS with PanOS 10.2.7-h3 installed and we are facing a problem. If we use predefined certificates, the cluster works fine, if we use custom certificates, som
...
Hello,
is it possible to show a list of automatically blocked IP addresses (example: Threat prevention for Brute-Force Attacks).
And is it possible to remove an IP from that list?
Thanks
Jörg
When I am logged in via SAML, I noticed that I was not able to remove other users' locks. Seems like this may be because I am not a superuser? Is there any way to make a SAML-authed user be a superuser?
We're testing upgrading to version 2.5.x and have run into a few changes with the new features.
We enabled "Use Default Browser for SAML Authentication", because you know ie, is going away. After doing this, each time our end user authenticates, the
...
Hello, I have a PA-220 with PANOS 10.1.3 installed. I see IPv6 addresses in source/destination IP widget. It started from 10.1.x version
does anybody has the same issue?
hello
I would like to add a new IP address to create a new GP portal/gateway
the IP Address I have been given by the provider is not available to select as an IP Address
I created a tunnel and configured an IP address but that has not solved the i
...
hello
I have 2 x 440 series to configure for HA active/standby
I plan to use ethernet 1/5 , 6 , 7 & 8 for the Data & Control links
I have connected the interfaces to test
when I select interfaces under "HA Communications" only the management inter
...
Need sync help. About two months ago we noticed our passive 3250 would slowly not respond. It finally died, no console response. Opened ticket, had one RMA, powered it up. Imported the saved config we took before it died. Checked ip's, management set
...
Hi Expert ,
I would like to know about intregate authen captive portal itself for identify byod of palo alto with clear pass the clear pass have pull information with ldap my question is below
- Palo alto can connect just clear pass for authen
...
Hello,
I am not a firewall administrator I am an analyst who reports alerts on suspicious behavior based on indicators of compromise matches, mostly related to ransomware and IP addresses with bad reputation.
I have a big doubt because I always g
...
Raido_Rattameis
