New to Prisma access - Cisco to Prisma VPN question

pingpilot — Wed, 26 Aug 2020 12:31:39 GMT

Hi,

Any pointers appreciated on this. We have connectivity to Prisma via IPsec without a Cisco VTI/tunnel interface. I would like to change this so that we use Cisco VTI/tunnel at the remote access site. How do I create a VTI in Prisma access for an IPsec tunnel to a remote access network Cisco site? I am expecting somewhere to apply ip address 10.1.1.238 255.255.255.252 within Prisma so that I can ping this address from the Cisco remote access site, but it is eluding me. Is this even possible what I want do to?

Cisco Remote access network site config example is as follows:

interface Tunnel59
description --PA Prisma--
ip address 10.1.1.237 255.255.255.252
tunnel source x.x.x.x
tunnel mode ipsec ipv4
tunnel destination x.x.x.x
tunnel protection ipsec profile PALOPROFILE

Thanks in advance

Re: New to Prisma access - Cisco to Prisma VPN question

MarkBoucher — Sat, 12 Dec 2020 10:28:57 GMT

Prisma Access VPN service is a cloudbased VPN offering, and is a VPN istcontrib:Cisco AnyConnect VPN Landing Page offering, which it will eventually replace. Frequently Asked Questions; Have Questions or Still Need Help? As the new VPN service is a cloud-based solution, it provides the ability

topic Re: New to Prisma access - Cisco to Prisma VPN question in Prisma Access Discussions

New to Prisma access - Cisco to Prisma VPN question

Re: New to Prisma access - Cisco to Prisma VPN question