topic Re: SDWAN interface configuration in template in Prisma SD-WAN Discussions

SDWAN interface configuration in template

G.Thomas500655 — Wed, 31 May 2023 15:06:43 GMT

Commit fail:
Details:
. Validation Error:
. network -> interface -> sdwan -> units -> sdwan.100 -> interface 'ethernet1/1' is not a valid reference
. network -> interface -> sdwan -> units -> sdwan.100 -> interface is invalid
. Error: SD-WAN is not enabled for member interface (ethernet1/1)
. Error: interface configuration error
. (Module: device)
. Commit failed

However SD-WAN is enabled on ethernet 1/1
Enable SD-WAN (check): SD-WAN Interface Status: Enabled
SD-WAN Interface Profile: Hub Internet

Any clues as to where to start troubleshooting this? Thanks.

Re: SDWAN interface configuration in template

wkazmierczak — Tue, 31 Oct 2023 15:05:33 GMT

network -> interface -> sdwan -> units -> sdwan.100 -> interface 'ethernet1/1' is not a valid reference

If SDWAN checkbox and sdwan interface profile is enabled on interface eth1/1 then that error probably means that somewhere in configuration you are referring to interface ethernet1/1 and the configuration do not know what is it interface "ethernet1/1".

Check your configuration especially if you are configuring ethernet1/1 and sdwan.100 in the same template.

If you can not find the error just put your template configuration with sdwan.100 from panorama.