topic Re: CLI to create Address Object and Address Group in General Topics

CLI to create Address Object and Address Group

JiaXiang — Wed, 22 Dec 2021 03:33:33 GMT

I need to create 800 IP address and Address group into Panorama. May I know what is the CLI command able to help me to do it ?

I have tried below command but return as invalid.

set device-group D-DMZ address H-xx.xx.xx.xx ip-netmask xx.xx.xx.xx
Unknown command: set

#CLI

Re: CLI to create Address Object and Address Group

PavelK — Sat, 25 Dec 2021 22:19:23 GMT

Thank you for the post @JiaXiang

The syntax of the command you posted is correct. The fact you are getting an error: "Unknown command: set" makes me think this is a privilege issue. Could you go Panorama and type:

> configure

If you have a privilege level to make changes you should see: "set" as one of the available commands. In order to make changes to Device Group the required privilege Level is either one of these: superuser, vsysadmin, deviceadmin

Kind Regards

Pavel

Re: CLI to create Address Object and Address Group

JiaXiang — Wed, 09 Feb 2022 02:58:51 GMT

Thanks Pavel,

After checking it is privilege's issue.