topic Re: How to determine Average Peak Traffic for PA-200 in General Topics

How to determine Average Peak Traffic for PA-200

Ebernardo — Thu, 13 Feb 2014 17:21:31 GMT

I am a newbie to the Pan-OS and would like to fine tune the Zone Protection profile - Syn flood settings, etc. based on our average peak traffic (packets per second). What is the easiest way to determine the average peak packets per second?

Re: How to determine Average Peak Traffic for PA-200

HULK — Thu, 13 Feb 2014 17:54:29 GMT

Hello Sir,

You will get the packet rate from CLI command:

admin@PAN> show session info | match rate

Packet rate: 4/s >>>>>>>>>>>>>>>

New connection establish rate: 0 cps

Session accelerated aging: True

Accelerated aging threshold: 80% of utilization

Pcap token bucket rate : 10485760

You can use the ACC report to get traffic trend through your PAN firewall ( based on session, Byte,Threat).

Protection profile settings apply to the ingress zone (i.e. the zone where traffic enters the firewall). Zone protection settings apply to all interfaces within the zone for which the profile is configured.:

For your reference:

Threat Prevention Deployment Tech Note

Understanding DoS Protection

Note: Zone protection is only enforced when there is no session match for the packet. If the packet matches an existing session, it will bypass the zone protection setting.

Thanks

Re: How to determine Average Peak Traffic for PA-200

HULK — Thu, 13 Feb 2014 17:57:38 GMT

Related discussion thread:

Zone Protection Flood Protection Max Packets per Sec And new sessions per second values.

Re: Apply zone protection - to which zone?

Thanks

Re: How to determine Average Peak Traffic for PA-200

Ebernardo — Thu, 13 Feb 2014 18:31:14 GMT

Thanks for the tip!

So, if my packet rate hovers between 200-800 s , is it safe to assume that the defaults of 10,000 in Zone Protection profile are too high of threshold? What would be ideal?

Re: How to determine Average Peak Traffic for PA-200

HULK — Thu, 13 Feb 2014 18:58:23 GMT

Hello Sir,

I do agree that 10,000 packet/sec would be high compared to the current packet rate. But, also I would recommend you to take a statistics of packet rate for last 7 days and accordingly configure a safe limit on your production PAN firewall.

Thanks