topic Re: IPSEC aggressive exhange mode and enable passive mode in General Topics

IPSEC aggressive exhange mode and enable passive mode

Gregoux — Mon, 06 Jan 2014 15:25:43 GMT

I woulld like to understand the advanced IPSEC gateway configuration.

between to ike gateway on with a static ip address and the other with a dynamic ip allocated.

to established the phase 1, i need to set the aggressive mode on both firewall or only on the one with dynamic ip allocated?

and when I need to activate the enable passive mode?

thank's

Re: IPSEC aggressive exhange mode and enable passive mode

mr.linus — Mon, 06 Jan 2014 15:34:34 GMT

1) the mode (main or aggressive) should be the same on both firewalls. so in case of dynamic ip -> set both to aggressive

2) passive mode -> this means that the PA will not initiate a VPN (but will listen to on being initiated to him).

Re: IPSEC aggressive exhange mode and enable passive mode

mr.linus — Mon, 06 Jan 2014 15:36:44 GMT

passive mode

- You don't need to enable this for VPN with dynamic IPS.

- This is handy for troubleshooting VPNs, since only the receiving side has advanced logs which can indicate the problem (the initiator will mostly only see "timeout"). So if you enable this you will always be the receiving side and thus have more logging...

Re: IPSEC aggressive exhange mode and enable passive mode

Gregoux — Mon, 06 Jan 2014 15:47:32 GMT

thank's for this

Re: IPSEC aggressive exhange mode and enable passive mode

mjensen40400 — Fri, 10 Jul 2020 14:58:13 GMT

I have a IKEv2 site to site IPSEC VPN and I am trying to enable aggressive mode. I can't find the option for aggressive mode anywhere?

Re: IPSEC aggressive exhange mode and enable passive mode

jjosephs — Mon, 17 Oct 2022 17:11:39 GMT

The Mode selection is available for IKEv1. Your IKE Gateway would need to be configured for IKEv2 Preferred or IKEv1 Only to see this option under the Advanced Tab