Set zone to "any" in CLI

BBartik — Wed, 01 Mar 2023 01:29:52 GMT

How can I set the zone for a rule to any in the CLI? If I delete the from / to lines it sets it to "none" which is not valid. If I set it to "any" then it thinks "any" is the name of the zone which is also incorrect. Any ideas?

Thanks!

Re: Set zone to "any" in CLI

Raido_Rattameister — Wed, 01 Mar 2023 02:45:02 GMT

If you want to see how current rules are set up in cli use following commands:

> set cli config-output-format set
> configure
# show | match "rulebase security rules"

For example this will do the trick permitting any/any

set rulebase security rules "Test Rule 1" to any
set rulebase security rules "Test Rule 1" from any
set rulebase security rules "Test Rule 1" source any
set rulebase security rules "Test Rule 1" destination any
set rulebase security rules "Test Rule 1" source-user any
set rulebase security rules "Test Rule 1" category any
set rulebase security rules "Test Rule 1" application any
set rulebase security rules "Test Rule 1" service any
set rulebase security rules "Test Rule 1" source-hip any
set rulebase security rules "Test Rule 1" destination-hip any
set rulebase security rules "Test Rule 1" action allow

topic Re: Set zone to "any" in CLI in General Topics

Set zone to "any" in CLI

Re: Set zone to "any" in CLI