topic Re: conversion to advanced routing engine failed in General Topics

conversion to advanced routing engine failed

nevolex — Fri, 07 Apr 2023 12:27:36 GMT

I tried to convert to a advanced routing engine using built in script in version 10.2.4 (pa 440) it converted with the yellow status

after reboot I noticed that non of my static routes work and each static route now has an additional entry for vrf that is not listed in the guide below, put 1 there - it did not make any difference

https://docs.paloaltonetworks.com/pan-os/10-2/pan-os-networking-admin/advanced-routing/enable-advanced-routing

https://docs.paloaltonetworks.com/pan-os/10-2/pan-os-networking-admin/advanced-routing/create-a-static-route#id64ef0e5f-fd93-4d16-a915-e81f6b34f6fb

can somebody please advise

thank you

Re: conversion to advanced routing engine failed

nevolex — Fri, 07 Apr 2023 23:29:51 GMT

here is the actual config, I have deleted the static routes prior upgrade, yet still got the error message

my virtual router had nothing special, not sure why the script couldn't migrate it properly

Re: conversion to advanced routing engine failed

nevolex — Sat, 08 Apr 2023 06:09:46 GMT

I have removed dampening profile from bgp it made the conversion script to run ok, got green status at the end however the static routes are still not working, the router engine follows the default route instead of the static route

I think the issue is that line towards the bottom of each static route, no mater what i put there, it never saves, I think it should not be thre in the 1st place in the official palo alto guide it's not there