Howto read out ICMPv6 Token Bucket statistics?

wimjuste — Fri, 26 Oct 2012 12:48:16 GMT

Hi,

Would there be a way how to read the statistics about the usage of the ICMP IPv6 token-bucket?

Additionally what is the relation between token based rate limiting as a global device setting and the
ICMPv6 CPS rate limiting in on a per zone configuration setting?

Thank you,

Kind regrads,

Wim

Re: Howto read out ICMPv6 Token Bucket statistics?

mikand — Sat, 27 Oct 2012 07:50:16 GMT

According to the admin manual:

Device > Setup > Session

ICMPv6 Token Bucket Size

Enter the bucket size for rate limiting of ICMPv6 error messages. The token bucket size is a parameter of the token bucket algorithm that controls how bursty the ICMPv6 error packets can be (range 10-65535 packets, default 100).

ICMPv6 Error Packet Rate

Enter the average number of ICMPv6 error packets per second allowed globally (range 10-65535 packets/sec, default 100). This value applies to all interfaces.

Network > Network Profiles > Zone Protection

Flood Protection Thresholds - ICMPv6 Flood

Alarm Rate

Enter the number of ICMPv6 echo requests (pings) received per second that triggers an attack alarm.

Activate Rate

Enter the number of ICMPv6 packets received per second for the zone that causes subsequent ICMPv6 packets to be dropped. Metering stops when the number of ICMPv6 packets drops below the threshold

Maximal rate

Enter the maximum number of ICMPv6 packets able to be received per second. Any number of packets exceeding the maximum will be dropped.

The stuff in device session only seems to monitor error packets while the stuff in zone protection is echo requests for alarm rate and all icmp packets for activate/maximal rate.

So a followup question might be shouldnt the token bucket size always be equal or larger than the error packet rate (since they both act on the same type of packets)?

To me the natural setting to display this statistics would be "show counter", but the manual isnt really clear of what all suboptions might bring you. Perhaps "show counter category fpga" could display these values?

topic Re: Howto read out ICMPv6 Token Bucket statistics? in General Topics

Howto read out ICMPv6 Token Bucket statistics?

Re: Howto read out ICMPv6 Token Bucket statistics?