topic Destination NAT on a Vwire? in General Topics

Destination NAT on a Vwire?

kentjday — Wed, 10 Sep 2014 14:32:18 GMT

Is there documentation on how to do this? All I have found is incomplete. Is the Destination Zone the same or different than the Source Zone? Do the addresses have to include the subnet mask? Are there any complete examples available?

Re: Destination NAT on a Vwire?

dburns — Wed, 10 Sep 2014 14:37:23 GMT

Understanding PAN-OS NAT

Page 26, have you reviewed this yet?

Dominic

Re: Destination NAT on a Vwire?

kentjday — Wed, 10 Sep 2014 14:43:56 GMT

Yes, it shows a vwire NAT policy. It mentions that a vwire NAT security policy is needed but doesn't show it. It also uses names instead of IPs so I don't know if the names include masks.
I also tried the Static NAT policy example but it didn't work either.

Re: Destination NAT on a Vwire?

dburns — Wed, 10 Sep 2014 14:51:32 GMT

Page 21 shows you the objects.. no subnets

When you look at the session is the NAT rule being matched and NAT not applied? Or not matched at all.

To view the session live from the CLI use the following;

pa> show session all filter source <ip> destination <ip>

pa> show session id <id>

Look for NAT rule

Dominic

Re: Destination NAT on a Vwire?

kentjday — Wed, 10 Sep 2014 15:02:37 GMT

ok, my objects do not have subnets either.

No Active Sessions...

Pretty aggravated - I appreciate your help very much!

Re: Destination NAT on a Vwire?

HULK — Wed, 10 Sep 2014 15:03:26 GMT

Hello kentjday,

Just to let you know, the Virtual Wire NAT will only support IP address translation on an address which is not on the same subnet as the endpoint which is directly connected to our firewall.

Thanks

Re: Destination NAT on a Vwire?

kentjday — Wed, 10 Sep 2014 15:07:06 GMT

My public address is x.x.106.137

My private address is 192.168.100.1

So if I understand your statement correctly I think they should work.

Re: Destination NAT on a Vwire?

dburns — Wed, 10 Sep 2014 15:07:55 GMT

"No Active Sessions…"

There's your first problem. Doesn't look like the traffic is even hitting the VWIRE. In the 'show session all filter' command you used Pre-NAT IPs to filter correct?

Re: Destination NAT on a Vwire?

kentjday — Wed, 10 Sep 2014 15:09:32 GMT

Yes, and then I tried "show session all". the same response.

Re: Destination NAT on a Vwire?

dburns — Wed, 10 Sep 2014 15:13:19 GMT

ok nothing to do with NAT the V-wire is not working at all. I would start with checking the V-wire configuration and security policy.

Re: Destination NAT on a Vwire?

HULK — Wed, 10 Sep 2014 15:14:54 GMT

FYI.. This is not supported:

Thanks