topic Re: PAN FW to DSL Modem in General Topics

PAN FW to DSL Modem

Javith — Thu, 29 May 2014 07:36:49 GMT

PC(trust zone-172.16.10.98/24)->(eth1/1-172.16.10.100)PAN FW(eth1/2-192.168.1.104/24)->(192.168.1.1/24) DSL modem(untrust)

My vr config: Destination:0.0.0.0/0, Interface:eth1/1, Next hop:192.168.1.1/24

my security policy: trust to untrust -any any

my Nat: no source/dest NAT.

Now i cant accesss internet from my PC(172.16.10.98/24)

Any additional config needed?

Thanks

Re: PAN FW to DSL Modem

HULK — Thu, 29 May 2014 08:04:44 GMT

Hello Javith,

The modem is not having return route, how to reach 172.16.10.0/24 subnet. Hence, i would recommend you to configure a source NAT on PAN FW as mentioned below:

From Zone- trust

To zone- untrust

Source : 172.16.10.0/24

Destination - any

NAT- dynamic-ip and ports ( ethernet 1/2-192.168.1.104)

So, all traffic coming from 172.16.10.0/24 subnet now source IP change to 192.168.1.104 and for the return traffic, the modem is having route ( directly connected) for 192.168.1.104.

Please let us know the result.

Thanks

Re: PAN FW to DSL Modem

Javith — Thu, 29 May 2014 09:11:55 GMT

Hi Hulk,

Thanks for ur reply..But Nothing happened

From the firewall(172.16.10.1-inband access)..I can ping eth1/2-192.168.1.104/24 but i cant ping 192.168.1.1/24 (DSL modem)

From internal pc(172.16.10.98/24) i can ping 172.16.10.1 but i cant ping 192.168.1.X

Please guide

Re: PAN FW to DSL Modem

HULK — Thu, 29 May 2014 14:17:14 GMT

Hello Javith,

Could you please verify the traffic logs ( GUI > Monitor > Logs > Traffic) and see some more formation. GUI --> Traffic log, you may use filters like ( addr.src in IP_ADD_OF_THE_TESTING_PC ) and ( addr.dst in IP_ADD_OF_THE_DESTINATION ) to check the security policy that the traffic hitting. Also, you can check the real time session in the CLI by using 'PAN>show session all filter source IP_ADD_OF_THE_TESTING_PC "

Otherwise, we may ned to enable FLOW BASIC feature to understand the exact reason behind the drop:

> debug dataplane packet-diag clear all

> debug dataplane packet-diag set filter match source IP_ADD_OF_THE_TESTING_PC destination IP_ADD_OF_THE_DESTINATION

> debug dataplane packet-diag set filter match source IP_ADD_OF_THE_DESTINATION destination IP_ADD_OF_THE_TESTING_PC

> debug dataplane packet-diag set log feature flow basic

> debug dataplane packet-diag set log feature tcp all

> debug dataplane packet-diag set filter on

> debug dataplane packet-diag set log on

~~~~~~~~~~~~~~~~ Initiate traffic through the PAN firewall/try to browse a website ~~~~~~~~~~~~~~~~~~~~~~~~~

> debug dataplane packet-diag set log off

> debug dataplane packet-diag aggregate-logs

> less mp-log pan_packetdiag_log.log

For more information, you can follow the DOC: Packet Capture, Debug Flow-basic and Counter Commands

Thanks