topic Re: Forefront UAG Direct Access in General Topics

Forefront UAG Direct Access

Retired Member — Thu, 18 Nov 2010 20:03:53 GMT

I was wondering if anyone has deployed Microsoft Direct Access or Forefront UAG behind a Palo Alto firewall, and could share their experiences. Direct Access requires 2 consecutive public IPv4 addresses (no NAT), and we are trying to figure out the best way to route this through a PA-2020 that currently has layer 3 interfaces configured, with a public IP range assigned on the external/untrust interface and NATed RFC1918 addresses on all of the other interfaces. Any advice would be appreciated.

Re: Forefront UAG Direct Access

swhyte — Mon, 22 Nov 2010 22:50:25 GMT

If you must keep the public addresses on the Forefront and absolutely NO NAT. Then what about setting up a virtual wire pair on the paloalto device and plugging the forefront into the trust side of it...You can plug the untrust side of the virutal wire pair into what ever switch you currently have the forefront plugged in to.

thanks,

Stephen

Re: Forefront UAG Direct Access

gwhyte — Thu, 31 Oct 2013 18:58:13 GMT

Abelgard, just curious if you might have updated to the new version of Direct Acess? If so, have you attempted to implement user awareness on your PA of incoming DA traffic? If so, how's that working for you, and how did you do it? Thanks!

Re: Forefront UAG Direct Access

Retired Member — Fri, 01 Nov 2013 17:51:46 GMT

We actually decided not to deploy DA... we were never able to get it working.