topic Re: PPPoE on Active/Active HA configuration in General Topics

PPPoE on Active/Active HA configuration

BLepenik — Wed, 16 May 2012 15:19:48 GMT

Hi,

I try to configure PPPoE on Active/Active HA system (2xPA-500). Configuration went OK, but PPPoE stays disconnected. No log entries in System log. After changing to Active/Pasive mode PPPoE starts get connected.

Is PPPoE supported on Active/Active HA system ?

Re: PPPoE on Active/Active HA configuration

mikand — Thu, 17 May 2012 17:10:53 GMT

To which interface do you connect the PPPoE configuration?

If im not mistaken I think there might be a difference regarding this if you use A/A HA (like connect to a virtual interface instead of a physical or something like that).

Re: PPPoE on Active/Active HA configuration

BLepenik — Fri, 18 May 2012 05:51:44 GMT

Hi,

I try to configure L# subinterface but you can not configure PPPoe on an L3 subinterface.

As far as I know you can configure PPPoE on physical interface only.

With best regards,

Bojan Lepenik

Vodja projektov sistemskih rešitev

T: +386 2 33 00 216 / M: +386 51 312 097

/ bojan.lepenik@lancom.si

LANCom d.o.o.,Tržaška cesta 63, 2000 Maribor, T +386 2 33 00 300,  +386 2 33 00 309, www.lancom.si

 Z majhnimi dejanji lahko obvarujemo naravo. Preden sporočilo natisnete pomislite na okolje