topic WF-500 Configuration Help. in General Topics

WF-500 Configuration Help.

Satish — Fri, 13 Feb 2015 12:30:42 GMT

Dear Friends,

I am facing some challenge during the WF-500 configuration. please find the below configuration

MGT FW- IP :- 192.168.1.10/26

GT- IP :- 192.168.1.2

MGT WF -IP :- 192.168.1.11/26

GT :- IP :- 192.168.1.2

But problem is that, when we are try to check admin@WF-500> show wildfire last-device-registration all :- status is failed.

firewall side

admin@PA-5020> show wildfire status :- wildfire is disable.

Please suggest.

Regards

Satish

Wenar — Fri, 13 Feb 2015 16:07:34 GMT

Can the WF Appliance ping the MGT interface of the firewall and has it internet access?

Did you configure service routes on the pa-5020 for wildfire?

Satish — Sun, 15 Feb 2015 15:56:38 GMT

Hi Wenar,

Thanks for your reply but i am able to ping FW to WF and WF to FW. FW in TAP mode so no need to service route.

Regards

Satish

ymiyashita — Tue, 17 Feb 2015 03:38:03 GMT

My suggestions:

- Make sure that there's file blocking profile with the action set to "Forward" or "Continue-Forward" and it's enabled.

- Run "test wildfire registration" (or "request wildfire registration" if your PA-5020 is running 6.0.x or above.)

- Put the entire output of "show wildfire status" to this discussion.

Regards,

Yasu