topic Site to site with netgear V7610 Telstra gateway. in General Topics

Site to site with netgear V7610 Telstra gateway.

inderjit21 — Mon, 12 Sep 2016 04:07:59 GMT

Has anyone configured site to site between PA200 and V7610 netgear box which Telstra provides.

Can it be done ,any issues ????

Re: Site to site with netgear V7610 Telstra gateway.

TranceforLife — Mon, 12 Sep 2016 12:08:45 GMT

Hi,

I never done it but if the Netgear support traditional IPSec don't think you will get any issues. This is a standard protocol, so should not be any probs. But l just done some research and not sure if this router supports full IPSec options. Config guide below:

http://www.telstra.com.au/content/dam/tcom/small-business/bundles/pdf/telstra-gateway-prov7610-configuration-guide.pdf

So cannot see options for IKE P1 and IKE P2 . You only able to configure gateway and PSK. And the example in the configuration guide explains how to do it between two Netgear V7610 routers. You could try to get their preconfigured IKE P1 and IKE P2 options and match with the Palo to see if it will work for you.

Thx,
Myky

Re: Site to site with netgear V7610 Telstra gateway.

VinceM — Thu, 15 Sep 2016 09:01:09 GMT

Hi,

Try not to use SHA1 and don't forget proxy ID

Re: Site to site with netgear V7610 Telstra gateway.

inderjit21 — Fri, 21 Oct 2016 02:51:44 GMT

Has anyone tried configuring site to site ipsec with a netgear which doesnt have phase1 and phase2 options.

Re: Site to site with netgear V7610 Telstra gateway.

TranceforLife — Fri, 21 Oct 2016 08:30:43 GMT

Are you referring to the same router model or different Netgear? In any case, you need to make sure that device is supports traditional IPSec VPN and get from the Netgear their predefined IKE P1 and IKE P2 setting similar way as Azure of AWS provides to you.