topic PA VM Interfaces Not Appearing in General Topics

PA VM Interfaces Not Appearing

cpatte7372 — Wed, 14 Sep 2016 13:16:36 GMT

Hello Community,

I'm in the process of building a new PA VM. I've added the interfaces in ESXi and rebooted. However, the interfaces still don't appear when I issue the command show interface all, see images below.

Can someone let me know what I'm doing wrong?

Regards

Carlton

Re: PA VM Interfaces Not Appearing

TranceforLife — Wed, 14 Sep 2016 20:55:22 GMT

Hi,

Interesting. VM should have 10 interfaces (including a mgmt intercase) and it is "max" for the VM series. They are preconfigured with OVA file regardless if you are done mapping on the ESXi host or not. Do you see any of these in the GUI, network, interfaces tab? If not and if it is a new fresh install just delete VM and re-install it again.

Thx,

Myky

Re: PA VM Interfaces Not Appearing

cpatte7372 — Wed, 14 Sep 2016 18:03:13 GMT

Thanks MyKy,

I got it working with a fresh install.

Cheers

Re: PA VM Interfaces Not Appearing

Sanjay_Ramaiah — Fri, 14 Jun 2024 07:55:30 GMT

@cpatte7372 you installed it with the new OVA file or it is just the same OVA but clean install?

Also to know was the Management interface was up and only the data plane interfaces eth1/1 or any other interface you configured had issues?

I am facing the similar issue with the VM firewall installed on ESXi, please suggest.

Regards,

Sanjay S

Re: PA VM Interfaces Not Appearing

zkay — Sun, 25 Aug 2024 21:56:30 GMT

I was more looking for a permanent fix, but to maybe get you or others going, there are a few things you can do to help with Palo Alto VMs.

1. Add a serial port to the VM. Different virtualization platforms do this differently, but it has fixed plenty of boot issues for me. Same with Panorama. This fixes problems with KVM, AWS, ESXi, and Nutanix (AHV).

2. Don't enable IPv6. For some reason, at least with VMware, I have noticed that when I have IPv6 enabled on my interfaces and try and boot the firewall, the dataplane interfaces do not show up. You can get around this issue, but it sucks.

To get around it, disconnect all the VM NICs except the management NIC by unchecking the "Connected" AND the "Connect At Power On" boxes.
Gracefully power off the VM.
Power back up the VM.
Wait for it to come fully back online. IE you can log into the management interface.
Check the "Connected" box on the NICs you need. They will magically start working this time, until the next reboot.
- I have likely done some of this to myself as I have upgraded the VM hardware to version 8, and you are not supposed to. I also have a PPPoE interface, so maybe no one else ever runs into this issue.