topic Re: No management access https since reset to factory default PA-200 in General Topics

No management access https since upgrading to 6.0.1

froggyj — Fri, 11 Apr 2014 02:35:04 GMT

I have upgraded several devices from 5.0.8, but of course the last one has to give me grief. Since upgrading from 5.0.8 to 6.0.1, I can no longer ssh or https to the management port (or any other interface on the firewall). The only way I can get on the box is to ssh to a router that is directly connected, then ssh from there to the firewall (PA3020). Once I got on there I did restart it again for good measure but nothing changed. Verified there is no asymmetric routing issue and verified "show deviceconfig system service" that https is not disabled. I also changed http to not disabled and I can't access it even through http so it's not protocol specific or certificate related etc....Nothing else has changed, just a routine upgrade like every other site, but I'm getting stumped for ideas. I spend 2+ hours on the phone with TAC and got nowhere, now waiting for the next tier....so thought I would throw it out there to the community in case someone has come across this scenario.

Re: No management access https since upgrading to 6.0.1

froggyj — Fri, 11 Apr 2014 05:26:47 GMT

I tried to revert back to 5.0.8 and the problem persisted. I then took down our MPLS and failed over to a secondary connection, same problem. Luckily I managed to be put in contact with Patrick at Palo Alto who was working night shift and this guy was brilliant! He identified a bug in 6.0.1 that only applies to the 3000 series PAN's. The fix should be out in 6.0.2 or 6.0.3 but if anyone else runs into this, the command you need to run (which is not in your config) is:

debug dataplane fpga set sw_aho yes

This command does not survive a reboot so when we upgraded to 6.0.1 and rebooted, we had to enter that command again. I'm back up and running and thankfully to Patrick I won't be pulling an all nighter. BIG GOLD STAR!

No management access https since reset to factory default PA-200

jjekes — Thu, 09 Mar 2017 15:22:56 GMT

I reset my PA-200 to factory default and i lost access through https, how do i re-enable it from the CLI

Re: No management access https since reset to factory default PA-200

TranceforLife — Thu, 09 Mar 2017 16:03:22 GMT

Do you have a mgmt access or console to the device?

https://live.paloaltonetworks.com/t5/Configuration-Articles/How-to-Configure-the-Management-Interface-IP/ta-p/60493

Re: No management access https since reset to factory default PA-200

jjekes — Thu, 09 Mar 2017 16:29:33 GMT

yeah and i can ping it, ssh is listenning but https doesnt seem to, how do i confirm it's listening on the device it's self ?

Re: No management access https since reset to factory default PA-200

TranceforLife — Thu, 09 Mar 2017 17:02:55 GMT

l think this should help:

> show config running | match disable

or configure

# show deviceconfig system service

service {
disable-telnet yes;
disable-http yes;
disable-https no;
disable-ssh no;
disable-snmp no;
disable-icmp no;

Re: No management access https since reset to factory default PA-200

jjekes — Thu, 09 Mar 2017 17:17:08 GMT

Thanks man, I will try it tomorrow