topic Any Any Rule in General Topics

Any Any Rule

SumitB — Wed, 30 May 2018 13:22:15 GMT

Many times I have seen that engineers used to allow any rule during troubleshooting and forget to remove which creates problem in audit and compliance check, is there any option so that engineers should configure rule with any in source/destination/port/application fields.

Thanks in advance,

sumIT

Re: Any Any Rule

OtakarKlier — Wed, 30 May 2018 14:28:40 GMT

Hello,

I have also run across this, unfortunatly there is not a way to prevent this. However there are a few workarounds that you can do to monitor their activity.

Have the PAN alert when changes are made
If you have a SIEM, have it alert when a rule is put in with an ANY statement
Train the engieneers to use 'Schedules' so that the rule is only in affect for a short time then expires

Hope that helps.

Regards,

Re: Any Any Rule

SumitB — Wed, 30 May 2018 14:49:44 GMT

Thanks, Otakar.Klier,

I have also enabled alert from SIEM but somehow once it's implemented then you cant do anything and in time of removal, you have to face some impact which traffic is already started moving through that Rule.

however, seems awareness and adherence are the only way to minimize this issue. Thanks once again.