topic Re: Software Upgrade Question in General Topics

Software Upgrade Question

mcw015 — Wed, 26 Sep 2012 15:03:54 GMT

When upgrading from PanOS 4.1.6 to 4.1.7, will the device fail over without issue as it installs the new software or will I have to schedule an outage? Thanks in advance.

-Matt

Re: Software Upgrade Question

sdurga — Wed, 26 Sep 2012 16:07:06 GMT

Hi Matt,

The device will have two internal storage partitions . Lets us Say that the 4.1.6 is installed on partition A . Now when you want to upgrade from 4.1.6 to 4.1.7 then the device will install 4.1.7 software in the partition B. Once the installation is complete , you have to REBOOT the device (causing an outage). This is required so that the device will switch its boot up partition to partition B to use the new image 4.1.7.

Thanks,

Sandeep T

Re: Software Upgrade Question

UhMayYeah — Wed, 26 Sep 2012 16:15:01 GMT

In case of a stand-alone firewall that needs to be upgraded, Reboot is needed for the Upgraded version to take effect,so an outage is inevitable.

If you are upgrading firewalls in active-passive HA pair ,

1>Upgrade Passive unit

2>Failover the HA pair.

3>Now upgrade the Passive unit (which was Active earlier)

This would e achieved with ideally no downtime.

P.S : In both the cases a scheduled window is always recommended.

-Ameya

Re: Software Upgrade Question

acamacho — Thu, 27 Sep 2012 22:30:56 GMT

Anytime you upgrade software the PA needs a reboot for the new image to load.

As my colleagues reported if you have a HA setup then you should upgrade the passive and then fail over to the passive so it will be come the new active.

Before you even upgrade the original active make sure traffic flows and verify functions like SSL vpn user can connect, IPSEC tunnels are up and traffic can pass.

One important thing to remember is when upgrading always export out the running-config.xml file from the PA before doing any upgrades.

To export out the configuration navigate over to the device tab.

Select the (setup) link

Select (operation tab)

Select (Export named configuration snapshot)

Select the running-comfig.xml file.

Let us know if you have additional questions.

Re: Software Upgrade Question

mcw015 — Fri, 28 Sep 2012 13:43:16 GMT

Thanks for the info. We weren't sure if the HA pair would operate on different versions of code. Our aruba stuff doesn't like to play nice when we upgrade the passive and fail it over while we try to upgrade the primary.

Re: Software Upgrade Question

acamacho — Fri, 28 Sep 2012 14:14:30 GMT

Upgrading the passive to different version is supported. What you will see on the dashboard is the version will be miss-match which is okay.

Once you fail over to the passive and it becomes active after you've confirm that all is work within the network then just upgrade the original active to match.

If you have any further questions do let us know.

Take care and have a nice weekend.