topic Re: debug dataplane process task on debug in General Topics

debug dataplane process task on debug

MP18 — Fri, 14 Dec 2018 04:43:35 GMT

below command

debug dataplane process task on debug

when we should use this command?

what does this command do?

Re: debug dataplane process task on debug

reaper — Fri, 14 Dec 2018 14:20:26 GMT

only use this when instructed by TAC to do so

it enabled (this logging is disabled by default) and increases log level to maximum for the dataplane software communications tasks

if used inappropriately it could cause serious side effects

Re: debug dataplane process task on debug

MP18 — Mon, 17 Dec 2018 18:57:30 GMT

Thanks for replying to the post.

I will not use this command on my own .

So when you say DP communication tasks does it mean with in the DP?

Between DP and MP?

Please explain this.

Re: debug dataplane process task on debug

MP18 — Mon, 17 Dec 2018 18:58:10 GMT

Also which command will show me the outout of debug dataplane process task?

Re: debug dataplane process task on debug

reaper — Tue, 18 Dec 2018 10:04:56 GMT

Ok, I feel like you're going to ignore my advice about not touching that command 😛

It is used to debug the traffic debug commands (flow basic Et al.) , so it operates at the lowest level and when the system is under tremendous stress

Enabling it if the conditions are not absolutely ideal will cause serious repercussions (i can't stress this enough)

It is added to the same logfile as flow basic so pan_task_x.log and after aggregation pan_packet_diag.log

Re: debug dataplane process task on debug

MP18 — Tue, 18 Dec 2018 14:51:51 GMT

Many Thanks Need to learn a lot from you.

Re: debug dataplane process task on debug

MP18 — Tue, 18 Dec 2018 14:58:27 GMT

I will use this command with great caution.

Check the DP load first then make sure filters are there for traffic pcap,then flow basic etc.

Will use this at LAB device first.