topic what can be the reason for and ( description contains 'HA Group 1: Peer HA2-Backup keep-alive down' in General Topics

what can be the reason for and ( description contains 'HA Group 1: Peer HA2-Backup keep-alive down'

MP18 — Sun, 13 Oct 2019 14:58:45 GMT

We have PA5220 HA2 backup connection on copper port running via switch.

today we got alerts on both active and passive firewalls.

and ( description contains 'HA Group 1: Peer HA2-Backup keep-alive down' )

and ( description contains 'HA Group 1: Local HA2-Backup keep-alive down' )

i check the physical interface no errors.

how can i know reason for this flap?

Re: what can be the reason for and ( description contains 'HA Group 1: Peer HA2-Backup keep-alive d

reaper — Sun, 13 Oct 2019 21:04:32 GMT

In short, they were each unable to ping the remote end. Did anything occur on the switch?was a port reconfigured, flapped, shut, disconnected,...? Are the firewalls connected to the same chassis or is there another link to consider?

Are the other HA links connected directly or via different switches?

Re: what can be the reason for and ( description contains 'HA Group 1: Peer HA2-Backup keep-alive d

MP18 — Sun, 13 Oct 2019 23:05:21 GMT

HA2 link is directly connected between firewalls.No switch involved.

HA2 connection goes via switch.

Verify switch is fine and no issues with switch port.

No errors on the switch port.

Nothing happened on the switch port,no config ,no flap etc.

Any logs i can check on PA side?

Re: what can be the reason for and ( description contains 'HA Group 1: Peer HA2-Backup keep-alive d

BPry — Mon, 14 Oct 2019 03:42:37 GMT

@MP18,

The system logs will just point you towards what @reaper already stated, the firewalls missed an ICMP response. If you aren't seeing anything on the switch at all as far as the port is concerned, I would look at the load and make sure the ICMP request wasn't dropped due to load.

Re: what can be the reason for and ( description contains 'HA Group 1: Peer HA2-Backup keep-alive d

MP18 — Mon, 14 Oct 2019 04:29:51 GMT

Hi BPry,

Thanks for replying.

For load I can use show running resource monitor?

Any specific cli command to check the load?

Also which logs i can see which shows firewall do the icmp ping to the passive firewall?

Regards

Mike