Error Setting up IKE Gateway: ID type and value must be specified

JuliusPIV — Tue, 07 Apr 2020 16:36:37 GMT

I'm very new to PAN equipment and am trying to get a site-to-site VPN setup on a PA-820 running 8.0.2 but am running into a pair of similar errors when trying to configure the IKE gateway.

The following commands:

set network ike gateway XY1-Z1 peer-id type ipaddr set network ike gateway XY1-Z1 peer-id id 11.22.33.44

Both result in the same error:

Server error : peer-id constraints failed : the peer ID type and value must be specified

Similarly, these two commands:

set network ike gateway XY1-Z1 local-id type fqdn set network ike gateway XY1-Z1 local-id id my-super-slick.fqdn

Both result in the same error:

Server error : local-id constraints failed : the local ID type and value must be specified

All of the other commands I'm running before and after those execute fine. I've done my best to scrutinize the syntax and manually verified via tab completion but I can't figure out what's wrong and I'm hard pressed to find solid CLI examples online to confirm see what might be different. (Link 1; Link 2)

Any thoughts on what I'm doing wrong (e.g.: order of operation) or missing is greatly appreciated.

Many thanks in advance!

Re: Error Setting up IKE Gateway: ID type and value must be specified

kiwi — Wed, 08 Apr 2020 11:41:15 GMT

Hi @JuliusPIV ,

I think you'll need to combine the type and id in one command ... like this:

set network ike gateway XY1-Z1 peer-id type ipaddr id 11.22.33.44

That seems to work for me.

Hope this helps.

-Kiwi.

Re: Error Setting up IKE Gateway: ID type and value must be specified

JuliusPIV — Wed, 08 Apr 2020 13:36:17 GMT

Excellent - that is correct thank you so very much!

topic Error Setting up IKE Gateway: ID type and value must be specified in General Topics

Error Setting up IKE Gateway: ID type and value must be specified

Re: Error Setting up IKE Gateway: ID type and value must be specified

Re: Error Setting up IKE Gateway: ID type and value must be specified