Command to Not Display Names in the CLI?

jeff6strings — Thu, 16 Jul 2020 14:18:32 GMT

In the Cisco ASA at the CLI there is a command to not display names but their IP addresses: no names.

Is there a similar command in PAN-OS; I'm using v 8.1.13? My goal is to list/export NAT policies without names as the individuals who will review this will recognize IP addresses.

Thanks for any help.

Jeff

Re: Command to Not Display Names in the CLI?

SutareMayur — Fri, 17 Jul 2020 05:57:15 GMT

@jeff6strings,

There are few cli commands in PANOS to list down the running NAT polices but it comes up with names.

show running nat-policy

show running nat-policy-addresses

But if you do some filter like shown below, it will not show the names for the NAT rule. Will show only addresses used in the NAT policy.

show running nat-policy | except index

show running nat-policy-addresses | except index

Hope it helps!

Mayur

topic Command to Not Display Names in the CLI? in General Topics

Command to Not Display Names in the CLI?

Re: Command to Not Display Names in the CLI?