Connecting PA820 to Cisco ASA HA

L0 Member

Connecting PA820 to Cisco ASA HA

Hi All,

 

I want to connect PA820 to ASA HA setup. ASA1 and ASA2 need to connect to PA820. Can I use link aggregation on PA820 for this scenario? If one of the ASAs fails will this setup work to pass on the traffic using the other ASA.

 

Thank you.

L7 Applicator

Re: Connecting PA820 to Cisco ASA HA

Hello,

So you have 2x ASA's and 1x PAN? Dont think an AE would work, I could be wrong. How about making the physical interfaces on the PAN layer 2 and making the vlan interface on the PAN layer3. This way the two PAN ports are just 'switch' ports.

 

Regards,

L7 Applicator

Re: Connecting PA820 to Cisco ASA HA

@sajidsil,

Actually AE ports would work perfectly fine here as the non-active port would simply be shown as 'down' as the HA process in ASA shuts down the ports. However, @Otakar.Klier's method is better then AE interfaces in this situation. 

Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the Live Community as a whole!

The Live Community thanks you for your participation!