10-29-2019 08:01 AM
When we try to access maintenance mode keeping "M" press the device just stop booting and nothing appears on console. Then if I press the M after some seconds just normal boot. We also try typing "maint" but no luck
10-29-2019 09:52 AM
Hello
Physical or Virtual FW?
It is a very fast and at times subtle timing issue.
You should be seeing a prompt that tells you that you need to press (and not hold) the M, to get it into Maint mode.
01-14-2022 07:56 AM
while the firewall is running normally, log into the CLI as a superuser. Give it the following command:
> debug system maintenance-mode
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
