Split-Brain Enable HA Config Change

L0 Member

Split-Brain Enable HA Config Change

We are setup as active/passive and have intentionally caused a split-brain with our firewalls (5050's) by removing one from vwire mode and removing all cables except mgmt port to perform some migration activities.  We left the "Enable HA" checked on both the primary and secondary. 

Question: We want to uncheck the "Enable HA" (primary first with a commit, then secondary) but want to verify that traffic will not be impacted when we perform this action (cause a reboot or make the primary unstable for some reason).

L7 Applicator

Re: Split-Brain Enable HA Config Change

Hello,

While it wont reboot, you will essentailly ahve two stand alone firewalls and back into a 'split-brain' since both would be 'active'. Another option might be to use the 'Suspend local device'. Its under Device -> High Availability ->Operational commands. This will ensure that the secondary will not take over any functions until its enabled again.

 

Regards,

Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the Live Community as a whole!

The Live Community thanks you for your participation!