only use this when instructed by TAC to do so
it enabled (this logging is disabled by default) and increases log level to maximum for the dataplane software communications tasks
if used inappropriately it could cause serious side effects
Thanks for replying to the post.
I will not use this command on my own .
So when you say DP communication tasks does it mean with in the DP?
Between DP and MP?
Please explain this.
Ok, I feel like you're going to ignore my advice about not touching that command :p
It is used to debug the traffic debug commands (flow basic Et al.) , so it operates at the lowest level and when the system is under tremendous stress
Enabling it if the conditions are not absolutely ideal will cause serious repercussions (i can't stress this enough)
It is added to the same logfile as flow basic so pan_task_x.log and after aggregation pan_packet_diag.log
I will use this command with great caution.
Check the DP load first then make sure filters are there for traffic pcap,then flow basic etc.
Will use this at LAB device first.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the Live Community as a whole!
The Live Community thanks you for your participation!