Creating a Log forwarding profile via GUI, configuration will not be displayed by show command.

Prerequisites
The content described in this article was verified with PAN-OS 8.0.12, PAN-OS 8.1.0, and PAN-OS 8.1.3 which is the latest at the time of posting.

Issue
In PAN-8.1.0 or later, if you create a Log forwarding profile via GUI, the configuration will not be displayed by the "show" command after login with ssh.

This is the result of the fix for the issue, which is the expected behavior.

This behavior is PAN-OS 8.1.0 or later.
In earlier PAN-OS versions, the configuration IS displayed by "show" command.

Cause

The reason for this behavior is that since the Log forwarding profile is set as the configuration of vsys 1 when using the GUI on a device that is operating with only one vsys, since the configuration does not exist within the range that can be viewed with the CLI command.

Therefore, it does not occur on devices with multi vsys enabled.
This issue does not mean that config can not be input by GUI operation.

By comparing and checking config, you can see that the setting contents are reflected.

WorkAround
You can avoid this behavior by submitting the config via ssh.
The image below shows the result of submitting the following commands via ssh.

# set shared log-settings profiles test match-list test send-to-panorama yes
# set shared log-settings profiles test match-list test log-type traffic
# set shared log-settings profiles test match-list test filter "All Logs"