ATTENTION Customers, All Partners and Employees: The Customer Support Portal (CSP) will be undergoing maintenance and unavailable on Saturday, November 7, 2020, from 11 am to 11 pm PST. Please read our blog for more information.
I am in the middle of preparation for moving one interface of PA cluster to new fabric. I would like to ask you for best approach to minimize the impact(no impact would be best). Appreciate any input.
My plan is now as follows:
1, Take configuration snapshot of Both members and import it to my local pc.
2, Uncheck the 'Enable config sync' under the Device>HA>General on both members and commit.
(My question here is, should I also click 'Suspend local device' on passive member? To prevent some unwanted failover. Would the members ne able to sync the session table after switching it on again?)
3, Starting work on Passive member. I already pre-configured Aggregate interface group with some interfaces inside. So I will create subinterface with Vlan, Zone, IPv4 and commit.
4. I will try ping next hop for the interface/subnet I created.
Now, here starts where I am not sure:
5. Next based on if 'Suspend local device' was used, I will either click 'Make local device functional' or if member was whole time active under cluster, I will switch to active member and initiate the failover. My question is, based on my plan, will the failover succeed?
6. Move configure the interface on old active, now passive member.
Forgot to add that I will also change the static routes via CLI so they point to new interface:
set network virtual-router default routing-table ip static-route "Route_1" interface ae1.300
And before committing the new interface configuration, I will delete the old interface configuration and old static routes.
After commit I will connect to CLI and paste static routes again with changed interface name/type. Going from ethernet1/10 to ae1.300 interface.
Sounds like you are planning correctly. IS this to replace the current HA pair? If the PAN's are different models make sure they are on the same code version and then it makes its super easy with exporting the config and importing into the new pair and then moving the cables.
Also i would suggest this be done in a maintenance window where downtime can be tolerated.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the Live Community as a whole!
The Live Community thanks you for your participation!