I have Cisco WLC and use ACS for radius authentication. I'm trying to configure PA FW to use those accounting logs for User ID. I'm following this article but it's not working https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000Cm8DCAS
Where it says, "Give the target a name and enter the IP address of the interface that will process the Syslog and use port 514". They are referring to the Management interface, correct?
When I run cli command, show user server-monitor state <Monitored server name>
The number of logs increases, but the number of auth success messages stay at 0.
I'm using ACS 5.8, PAN 8.1.4 and Cisco WLC
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!