This website uses cookies essential to its operation, for analytics, and for personalized content. By continuing to browse this site, you acknowledge the use of cookies.
For details on cookie usage on our site, read our Privacy Policy
Accept
Reject
General Topics
Post a discussion here if you have general questions regarding configuration and troubleshooting for Palo Alto Networks products. Use this forum to collaborate with like-minded security professionals to improve your security posture.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
General Topics
Post a discussion here if you have general questions regarding configuration and troubleshooting for Palo Alto Networks products. Use this forum to collaborate with like-minded security professionals to improve your security posture.
About General Topics
Post a discussion here if you have general questions regarding configuration and troubleshooting for Palo Alto Networks products. Use this forum to collaborate with like-minded security professionals to improve your security posture.

Discussions

Start a conversation

Resolved! PA-500 Upgrade to 4.0.3

Hi All,

I have just upgraded a PA-500 from 3.1.8 to 4.0.3 loading the 4.0.1 base first.

Once the unit rebooted the "Autocom" job has been stuck at 10% for the last 30 minutes and is still running.

Has anyone experienced this before, not sure if I should

...

question re split tunnelling

We are installing some PA 500 firewalls at various sites within our company

each site has 1 connection to the internet - my question is if I want to install a dynamic multipoint VPN tunnel to connect this site to the company network and all traffic wi

...

sue_town by • Not applicable
  • 1498 Views
  • 3 replies
  • 0 Likes

IPSEC tunnel due to timeout problem

I was configure remote 10 branchs connect to Office by IPSEC tunnel. Each branch connect to Office bandwidth  256kbps,512kbps, 1mbps. So someone branchs tunnel automatic disconnect.

Manual remote tunnel device(Cisco RV042) reconnect  to PA2020 error.

...

Amarzaya by • Not applicable
  • 8151 Views
  • 6 replies
  • 1 Likes
Top Liked Authors
View All
Labels
LEGAL NOTICES
RESOURCES
Copyright 2007 - 2023 - Palo Alto Networks