For details on cookie usage on our site, read our Privacy Policy
Destination NAT on a Vwire?
- LIVEcommunity
- Discussions
- General Topics
- Re: Destination NAT on a Vwire?
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Printer Friendly Page
Destination NAT on a Vwire?
- Mark as New
- Subscribe to RSS Feed
- Permalink
09-10-2014 07:32 AM
Is there documentation on how to do this? All I have found is incomplete. Is the Destination Zone the same or different than the Source Zone? Do the addresses have to include the subnet mask? Are there any complete examples available?
- Labels:
-
Networking
- Mark as New
- Subscribe to RSS Feed
- Permalink
09-10-2014 07:43 AM
Yes, it shows a vwire NAT policy. It mentions that a vwire NAT security policy is needed but doesn't show it. It also uses names instead of IPs so I don't know if the names include masks.
I also tried the Static NAT policy example but it didn't work either.
- Mark as New
- Subscribe to RSS Feed
- Permalink
09-10-2014 07:51 AM
Page 21 shows you the objects.. no subnets
When you look at the session is the NAT rule being matched and NAT not applied? Or not matched at all.
To view the session live from the CLI use the following;
pa> show session all filter source <ip> destination <ip>
pa> show session id <id>
Look for NAT rule
Dominic
- Mark as New
- Subscribe to RSS Feed
- Permalink
09-10-2014 08:02 AM
ok, my objects do not have subnets either.
No Active Sessions...
Pretty aggravated - I appreciate your help very much!
- vWire deployment using Same Switch on Untrust and Trust Side in General Topics
- Threat log Issue in General Topics
- URL Filtering is not working for Global Protect users in Next-Generation Firewall Discussions
- Is it possible to specify a source address for certain destinations when using Prisma Access? in Prisma Access Discussions
- PA-300 induced high latency for GP clients with just 200Mbps troubput in GlobalProtect Discussions
Show your appreciation!
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
