How was determine or verify after with application override bypass L7

Announcements

ATTENTION Customers, All Partners and Employees: The Customer Support Portal (CSP) will be undergoing maintenance and unavailable on Saturday, November 7, 2020, from 11 am to 11 pm PST. Please read our blog for more information.

Reply
Highlighted
L3 Networker

How was determine or verify after with application override bypass L7

Hi Expert ,

 

I would like to verify after config and traffic is match with Application Override Policy that it already bypass L7  how to check it via cli or gui so, I have understood about can check with show session id after filter application is already override but I have to clarify and verify it. 

 

Sorry to bad english 

Highlighted
Cyber Elite

@Pattarachai,

The only time that layer7 inspection is used after an override policy is hit is if you've setup the policy to override to a pre-defined application. The firewall won't do any application identification as it matched your override policy, but it will continue to do content threat inspection. 

 

tl:dr

If you override to a custom application then inspection stops at layer4, full stop. 

If you override to a pre-defined application then traffic will still receive content threat inspection. 

Building an override policy with a pre-defined application is not recommended.

Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the Live Community as a whole!

The Live Community thanks you for your participation!