Multicast over IPSEC between 2 PA devices

cancel
Showing results for 
Search instead for 
Did you mean: 

Multicast over IPSEC between 2 PA devices

Not applicable

PanOS Admin manual says multicast over ipsec is fully supported between PA devices. I just cant figure out how to configure it properly. I can get the receivers to show up on PIM, and I can see traffic going thru to the receiving side PA, but not forwarded from there.

Here is our wanted setup. Because our ISP won't allow multicast traffic through it's MPLS network, we have to tunnel it somehow.

Multicast.JPG

I have set PA1 as Static RP on Ethernet1.32 and configured PA2 to use it. Security rules for multicast traffic are currently set to allow any->multicast. Both PA's have IGMP and PIM enabled on tunnel.1 and internal Ethernet interfaces. I believe the solution lies in configuring the routes properly, but I can't figure it out and can't find any guides for this setup.

0 REPLIES 0
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!