08-14-2020 02:45 PM
I have a pair of VM 300s in active/active mode and everything is running OSPF. PA1 is primary and PA2 is standby. I noticed I was missing a bunch of traffic for anything going to the standby router. I can ping every interface on the standby sourced from the loopbacks on each router but I cannot route through the standby.
The OSPF table shows both PAs as available paths but anything going through the standby doesn't work. If I add static routes on the standby PA and both routers to force traffic through the standby it is broken 100 percent of the time. If I force traffic through the primary everything works. The same holds true if I flip the primary/standby where PA1 is standby and PA2 is primary the problem flips and again the standby cannot route traffic even though I can ping every interface on both PAs to include tunnels and loopbacks.
08-14-2020 02:46 PM
I threw the picture together quickly the RTR 1 address is 10.88.35.1 not 12.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
