Just posting this if others setting up PPPoE on new PA-220. There was one or two check boxes to complete so hopefully this saves others some time. The ISP for this one was Eircom, and used default PPPoE settings for that ISP.
Tab one -
Add a L3 interface, add to a Virtual Router and Zone
Tab - 2
Select PPoE radio button. Enter Default PPoE or other if available. Click advanced
Auth is Auto
Check the box for it to create a default route.
Check the box to say its passive
In the Virtual router the default route points to the PPoE interface and the next address is set to none.
Its the same for the Global Protect Gateways & portal if on the public interface.
Commit the changes and can see it connect from the network>interfaces section or in the system logs.
hope this helps,
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!