For details on cookie usage on our site, read our Privacy Policy
Routing issue with Palo alto
- LIVEcommunity
- Discussions
- General Topics
- Re: Routing issue with Palo alto
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Printer Friendly Page
- Mark as New
- Subscribe to RSS Feed
- Permalink
10-18-2021 10:59 AM
Hello everyone!
I am experiencing an odd problem.
I have 3250 HA pairs. I have configured 2 aggregate(L3 trunk) interfaces and added sub interfaces to these aggregate.
The first problem is the firewall itself can not ping directly connected device by using "ping source x.x.x.x host y.y.y.y" command.
Every sub interface has management profile assigned.
The each aggregate interfaces has connected to 2 cisco stack switches.(switchstack1---aggregate1-aggregate2---switch-stack2)
I set IP addresses on both switches, however, there is not connection between two switches even though they have default route towards palo alto. I can not even ping from switch to palo alto interface.
- Mark as New
- Subscribe to RSS Feed
- Permalink
10-18-2021 11:11 PM - edited 10-18-2021 11:11 PM
Strangly,I realized that only 1 sub if is able to ping firewall. firewall has three sub interface under aggregate 2.
Aggregate 2.31, ae2.32 and ae2.33
I am able to ping from ae2.32 connected router to firewall, but can not ping from other 2 sub interfaces connected router to firewall.
Same MGMT profile is used for all interfaces and A, B,C class ip addresses included in this MGMT profile.
Meanwhile, both devices are visible in the ARP table.
- After enabling Advanced Routing, all IPsec tunnels are down in Next-Generation Firewall Discussions
- ASA migration to PA in General Topics
- IKE phase 1 not working in General Topics
- Global protect VPN disconnecting multiple times in GlobalProtect Discussions
- Palo Alto BIOC rule content error [specific rule] in Cortex XDR Discussions
Show your appreciation!
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
