vwire loop into tap port for QoS demo

Showing results for 
Show  only  | Search instead for 
Did you mean: 

vwire loop into tap port for QoS demo

L3 Networker


To show QoS, when running a PoC using out of band traffic, will connecting a tap port via the factory v-wire interfaces work?

So out of switch mirroring traffic, into trust vwire->untrust vwire->tap ?



L4 Transporter

You are talking about a port mirror (span port) configured on a switch , right ? This requires to have a tap port configured on the PAN FW not a VWire port. You can not use a tap port to demo QoS.  You would need a VWire or Layer 3 interfaces configured on the PAN in order to demo QoS.  Roland

L4 Transporter

for demo purposes you can use this scenario. Get a tap port from switch and plug into in a one of the port pairs of vwire. You can then apply QoS rules to the VWire.

Thanks for that. Do I have to terminate the connection by connecting the outbound vwire into a tap port?

you can leave the port disconnected. Make sure you disable " link state pass through"

Do I disable that on the PAN side, or on the switch side, or both?

Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!