Hi All, I have an issue with a Template push to device issue. I have added some routes in the BGP import section and have committed to Panorama without issue. When I push to device I run into a couple of separate issues which is causing me problems. When I push to devices using the force template values I get issues concerning HA and this error: ha1-backup interface ipaddr configured to match peer-ip-backup address My setup is an active passive pair with unique management addresses, unique hostnames. HA is configured with unique IPs for Peer HA1 on both, pointing to the IP set on Control Link HA IP set on the opposite device. The backup HA is configured to work on the management interface and the peer set to opposite device IP. If I don't force template it is all okay, and it works apart from the config is not pushed. If I force the template, the passive device fails with the error above but the primary device has the config on. Question is how to resolve this through Panorama? If it can't, is it best to do this config on the device and is that achieved by selecting the "Disable Device and Network Template" in Device>Setup>Panorama settings? Secondary quicky question - is it best to have sync config ticked post migration to Panorama as the documentation wasn't clear whether to enable it or not? Regards Adrian
... View more