Just wondering if there was a resolution with this? From research apparently changing the Pre-Logon Tunnel Rename Timeout to 0 might help. This setting controls how GlobalProtect handles the pre-logon tunnel that connects an endpoint to the gateway. A value of -1 means the pre-logon tunnel does not time out after a user logs on to the endpoint; GlobalProtect renames the tunnel to reassign it to the user. However, the tunnel persists even if the renaming fails or if the user does not log in to the GlobalProtect gateway. A value of 0 means when the user logs on to the endpoint, GlobalProtect immediately terminates the pre-logon tunnel instead of renaming it. In this case, GlobalProtect initiates a new tunnel for the user instead of allowing the user to connect over the pre-logon tunnel. Typically, this setting is most useful when you set the Connect Method to Pre-logon then On-demand , which forces the user to manually initiate the connection after the initial logon. A value of 1 to 600 indicates the number of seconds in which the pre-logon tunnel can remain active after a user logs on to the endpoint. During this time, GlobalProtect enforces policies on the pre-logon tunnel. If the user authenticates with the GlobalProtect gateway within the timeout period, GlobalProtect reassigns the tunnel to the user. If the user does not authenticate with the GlobalProtect gateway before the timeout, GlobalProtect terminates the pre-logon tunnel.
... View more