About LashamM

Got it to work by unticking passive, and making sure the draytech vigor was set to default. Used Auto for authentication. ... View more

Got this to work. I used the default setup on the DrayTech Vigor 120. For the PPPoE settings I set it to Auto for authentication and UNticked Passive.   ... View more

did anyone get this working? ... View more

I had a brand new PA-220 running v10 and I setup a PPPoE connection to a DrayTech Vigor 120 running in bridge mode to PPPoA connection.  This works fine with an existing Ubiquiti USG device. It created the PPPoE connection, and got an IP address perfectly. Unfortunately at the time I had not created any policies or routes so could not use it. I restored a previous config from an older PA and from them on could not get the PPPoE to connect. It gets the PPP link up, sees that there is a DrayTech device connected but cannot establish the link.   I am going to try factory defaulting the PA220 tonight and see if I can start again and get it to work like it originally did. Not sure how the old config would stop it from working, as i've checked (multiple times) the interface with PPPoE is setup exactly the same as the original one that worked. ... View more