About MyhreNDS

MyhreNDS · ‎04-07-2015

I give up Convincing vendor to change IP in order to set up NAT.

MyhreNDS · ‎03-31-2015

For the internet connection I have only the untrusted interface for internet. There is only one interface on modem. And I dont want to set up switch either.

MyhreNDS · ‎03-30-2015

I considered both virtual wire and Layer 2 but this requires two interfaces? But have not been able to assign this to the Layer 3 untrusted interface. I have configured a lot of Palo Alto but never with this settings. The Palo Alto have been replaced from an SonicWALL firewall and this device was configured in transparent mode.

MyhreNDS · ‎03-30-2015

I need to setup router from vendor with official ip adress because it cannot use nat. It will support a service from Miele called "Miele Logic". Without setting this directly on modem wiith swith I want to sett this on interface at PA. I have not figured out what kind of design is best practis to use?

Member Since	‎03-19-2015 07:56 AM
Date Last Visited	‎08-18-2015 09:07 AM
Posts	4

Online Status	Offline
Date Last Visited	‎08-18-2015 09:07 AM

About MyhreNDS

Re: How to make access for another router thru PA-500

Re: How to make access for another router thru PA-500

Re: How to make access for another router thru PA-500

How to make access for another router thru PA-500

Re: How to make access for another router thru PA-500

Re: How to make access for another router thru PA-500

Re: How to make access for another router thru PA-500

How to make access for another router thru PA-500