About lavision

Thanks cramman, precisely what I needed!   ... View more

Thanks, exactly what I needed!. Reading the new global Counters now works. ... View more

The problem did not show again after upgrading to 5.0.3 ... View more

I also observed very slow response from the management interface after upgrading our PA500 fromn PanOs 5.0.1 to 5.0.2 My SNMP network monitoring showed the management CPU to be stuck at 100% load. A reboot temporarily solved this high load issue, but after some time the management CPU was again permanently at 100% load. My only resolution was to go back to 5.0.1, and this helped in my case. ... View more

I observe the same behaviour with my PA-500 after upgrading from 4.1.8 to 5.0.0 Anybody has a solution? ... View more

I opened a case and my problem seems to be reproducable. I will post an update as soon as I get a fix. ... View more

Dear sdurga, thanks for your debugging hints! Restarting the process didnt fix the problem. I reassigned the netflow profiles as suggested and found that everything is working fine as long as I use only one profile: cli shows that netflow packets are sent at reasonable rate(debug log-receiver netflow statistics) netflow data is send on the correct port defined in the profile (proved by the fact that the receiver is display the flows in the correct channel) each profile alone works on each interface The situation changes if I assign a second profile to one of my L3 interfaces: netflow receiver gets only data for one interface cli statistics shows that the second netflow profile is only generating data for each timeout interval (i.e. one packet each 5 minutes) it seems that data is only generated for the lowest interface number All interfaces are plain L3 type on the same virtual router. Software version is 4.1.8 Regards, Detlev Weide ... View more