This website uses Cookies. Click Accept to agree to our website's cookie use as described in our Cookie Policy. Click Preferences to customize your cookie settings.
About DexinLi
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- LIVEcommunity
- About DexinLi
04-25-2022
3Posts
0Likes
0Solutions
Apr 25, 2022Last Visited
User
Activity
User
Profile
Latest posts by DexinLi
| Subject | Views | Posted |
|---|---|---|
| 1089 | 04-24-2022 06:13 PM | |
| 1156 | 04-23-2022 06:35 PM | |
| 1270 | 04-22-2022 07:58 AM |
Posts I Liked
| Subject | Likes | Author | Latest Post |
|---|---|---|---|
| 1 Like |
User Badges
Community Statistics
| Member Since | 04-22-2022 05:18 AM |
| Date Last Visited | 04-25-2022 12:59 AM |
| Posts | 3 |
04-24-2022
06:13 PM
Thanks a lot, Pavel. Understand. Loopback interface of Firewall can't be redistributed as learned route by dynamic route protocol like cisco. Actually, I can advertise both lookback addresses into RIP and OSPF area in parallel and don't need worry about conflict issue.
... View more
04-23-2022
06:35 PM
Thank you so much, Gentlemen, for your prompt reply Let me illustrate my question with below diagram. Loopback0 is advertised into RIP and pingable from R1 Loopback1 is advertised into OSPF and pingable from R2 Do redistribute between RIP and OSPF. Loopback address of R1 is reachable from R2 and Loopback address of R2 is also reachable from R1. But Loopback0 of firewall can't reach from R2 and Loopback1 of firewall can't reach from R1. That's to say, loopback address of firewall can't be redistributed between protocols. Why? I test the same situation on cisco router, there's no problem. Any special settings is needed? Thanks
... View more
04-22-2022
07:58 AM
Dear experts I set a PA firewall as an ASBR, connects to a RIP and a OSPF area with eth1/1 and eth1/2 respectively. And created 2 loopback interfaces on PA, advertised them into RIP and OSPF respectively. Then I can reach them within RIP and OSPF area separately. Now I create redistribution profiles RIP-2-OSPF and OSPF-2-RIP, and apply them to OSPF and RIP. Finally, I only can reach the loopback address on cisco routers in two areas each other, but can't see the loopback address on PA. That is to say, I can't reach any PA's /32 host address which is advertised in RIP AS from OSPF and vice versa. Why? Any setting is missed by me? Thanks
... View more
LEGAL NOTICES
Copyright 2007 - 2023 - Palo Alto Networks