About JeroenvE

I had the same problem. After discussing with support they said I needed to remove and put back the circuit label on my DC nodes and that would fix it. Not ideal, but I tried it and it worked. If you do them one by one the outage is minimal, but I'm lucky to not have a 24/7 environment here. And it broke again later so I had to do it again. ... View more

This could be MTU issues, if your old solution had less encapsulation overhead. I haven't played around with settings, but there's an MTU option under the interface settings you could play around with. Also, check what traffic is lost. I've seen traffic in my network being blackholed because the flow got stuck in an invalid state but was never deleted because traffic kept coming. This was specifically udp and can be avoided by changing the timeouts in the application settings. ... View more

I've got the same problem. It manifests at the site level as well. When you check the "Link Quality" tab in the Activity Monitor, there is just no data even though I've checked the circuit settings and followed the steps in the deceptively titled "Administrator Guide". Turned on LQ monitoring Turned on LQ monitoring for non hub paths Selected my only datacenter site Tried both minimum and average aggregation Bandwith monitoring and QoS are also configured. I've tried different combinations of settings but nothing works. The network is operating fine but there's no LQ data being displayed. We are running version 5.6.7-b4 right now, preparing to upgrade to v6. This should not be the issue. ... View more