Hi All. I am in a postion that we would like to migrate our current cconfiguration of multiple trunk 10g links supporting a vlan with subinterfaces and vsys's to virtual wire mode on the existing chassis, (i.e. 7050, or 5060). As I understand it, we would need at least 2 interfaces for each trunk for both sides of the vwire, and then have matching subinterfaces under these vwire interfaces for each individual vlan. Since we would like to migrate vlan by vlan, is there a way that this is possible? For instance: current configuration 7050: 4-10g interfaces trunked for a single vrf, with multiple subinterface for indiviudal vlans and associated vsys's that support client servers etc(can think is as a client dmx) and another 4-10g interface trunk for the internal network side. The vsys have a interfaces one on the client vlan and one on the internal vlan. Since I am knew to virtual wire, but not Palo in general, what would be the best course of proceeding to migrate individual vsys/vlans to a vwire configuration. I assume we would need at least 2 10g interfaces 1 for client vlan, and 1 for internal to start with, and as we move we can add additional 10g interfaces to both sides to increase the available bandwidth needed? Any help would be appreciated. I have read most of the KB articales but they all seem to be directed to a single 1 to 1 interface. Also what if we have a vsys that had internet were we do not wish to vwire internet but the other would be client side and internal, I expect that we could not have vwire in this scenario based on what I have researched. Thank you in advance for any help.
... View more