About shabeeb

PavelK · ‎10-28-2021

Thank you for reply @shabeeb and sorry for late respnse. Yes, this is correct statement: only thing what we need to do is to configure the interfaces, floating IP address field of active-active HA and routing. Regarding floating IP address, only 1. Kind Regards Pavel

SteveCantwell · ‎03-23-2021

Hello What you are referring to, could be found in the deployment guides on PANWs website. here is a link to help you get started with the supported deployment types. https://docs.paloaltonetworks.com/vm-series/10-0/vm-series-deployment/set-up-the-vm-series-firewall-on-azure/deployments-supported-on-azure.html#id4317addf-0a0c-4e75-94ad-f63847f427f0 Good luck and let me know what other questions we can answer for you.

shabeeb · ‎07-09-2018

Hi All, The issue was that the vlans were not allowed in the virtual wire. Once I allowed the vlans everything worked fine. Thanks for the valuable replies guys.

Member Since	‎10-21-2017 02:28 AM
Date Last Visited	‎02-07-2022 07:11 AM
Posts	5
Total Likes Received	1

Online Status	Offline
Date Last Visited	‎02-07-2022 07:11 AM

About shabeeb

Re: Palo Alto IPV6 configuration for firewalls running in active-active HA

Palo Alto IPV6 configuration for firewalls running in active-active HA

Inbound NAT for multiple VMs through single Azure firewall

Re: Cisco Guest Mobility Anchor Controller Tunnels are down when placed behind Palo Alto firewall

Cisco Guest Mobility Anchor Controller Tunnels are down when placed behind Palo Alto firewall

Re: Cisco Guest Mobility Anchor Controller Tunnels are down when placed behind Palo Alto firewall

Re: Palo Alto IPV6 configuration for firewalls running in active-active HA

Re: Inbound NAT for multiple VMs through single Azure firewall

Re: Cisco Guest Mobility Anchor Controller Tunnels are down when placed behind Palo Alto firewall