OID for CPU/MEMORY on PAN 5050

[rob.burgoyne]

I'm looking for an OID to use for monitoring the CPU/MEMORY utilization with my NMS system. My MIB walk didn't turn up anything useful.

Thanks,

[sdurga · Accepted solution]

Rob,

Paloalto follows both HOST-RESOURCES-MIB and RFC1213 MIB.

5050 has a management plane cpu (mp) ,2 dataplane cpus (dp-0 and dp-1)

OIDs for cpu usage are as follows for each of these processors

mp - 1.3.6.1.2.1.25.3.3.1.2.1

dp-0- 1.3.6.1.2.1.25.3.3.1.2.2

dp-1-  1.3.6.1.2.1.25.3.3.1.2.3

The result of your query is CPU load average for the last 60 secs.

check this out

https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000ClaSCAS

also this link for host-resources-mib

HOST-RESOURCES-MIB SNMP MIB

[rob.burgoyne]

mp - 1.3.6.1.2.1.25.3.3.1.2.1 ----- value = 0.0

dp-0- 1.3.6.1.2.1.25.3.3.1.2.2 ----- value = 1

dp-1-  1.3.6.1.2.1.25.3.3.1.2.3----- value = not supported

Hrm, can't seem to get it to work. Any tricks that I should know about?

[rob.burgoyne]

I take that back, it is working! Thank you very much!

[Roby_Sreejith]

For me also it is not working. May i know how you get it worked

[Remo]

What exactly does not work?

SNMP community set correctly?

Firewalls between the one you want to monitor and your monitoring server allows snmp traffic?

[Roby_Sreejith]

When I test with OID for 5050 devices below are the results:

OID: 

Data plane -0- 1.3.6.1.2.1.25.3.3.1.2.2

When I test with OID : 

Data plane -1-  1.3.6.1.2.1.25.3.3.1.2.3

I am getting below error:

So I suspsect the OID"

Data plane -1-  1.3.6.1.2.1.25.3.3.1.2.3"  is not working 

For 5050 like 2 data planes , are there 2 OIDs require or with single OID will it show average value of all cores in 2 data planes?

[Remo]

There is only 1 average value for all cores/dataplane-processors.

--> 1 OID for MP CPU and 1 for DP CPU(s)

[Roby_Sreejith]

@RemoSo which means for data plane this OID only valid: Data plane -0- 1.3.6.1.2.1.25.3.3.1.2.2 ?

I have seen some reference for tfor Data plane -1- 1.3.6.1.2.1.25.3.3.1.2.3

Was it removed or is there any reference to say only one OID for devices like 5050 where mutiple data planes are used