Check Point R80.10 rules don't show

[tcarlisle-ksa]

I am using Expedition v1.1.17. I've imported a Check Point R80.10 config using the R80.10 (beta) tab. In each case all addresses, services,  etc are importing mostly properly, but security rules and NAT rules are not showing. The project dashboard does show the correct rule count, but there is nothing under policies. Am I missing something?

Thanks!

[sjanita]

in the lower right hand corner can you change the view from 'all' to 'vsys1' and verify if the policies are displayed.

[tcarlisle-ksa]

My options are: all, shared, or management server. None of them show the policies.

On a side note, I did find that the R80 import is working just fine. I'll take that path for now. It's just easier to get the config using the R80.10 instructions.

[dgildelaig]

Would it be possible to share the configuration with us to make sure that it contains all the objects required for the migration?

If so, you could send it to fwmigrate at paloaltonetworks dot com.

[tcarlisle-ksa]

Well I just did tried again and everything imported correctly. I must have just messed something up along the way.

Thanks for the help on this.